德爾格pac3500

德國德爾格Drager Pac3500測量準確，操作簡單,是理想的個人防護氣體檢測報警儀。此儀器可以快速連續檢測環境空氣中的一氧化碳，硫化氫或氧氣的濃度并及時報警，使用壽命2年，專為工業安全應用設計。

（現貨）技術參數：

功能測試快速可靠

功能測試可以檢查儀器是否工作正常。絕大多數國家規范要求用戶利用已知濃度氣體對儀器進行常規測試。功能測試可以檢查儀器是否正常工作。德爾格Pac 3500滿足不同的應用配置了可調節功能測試和標定間隔，到功能測試和標定要求日期屏幕上會自動顯示警告。如若忽略警告，儀器可自動顯示“出現故障”錯誤信息。用戶也可以選擇對標定間隔過期設置此錯誤信息提示。德爾格Pac 3500可以與德爾格功能測試儀配套使用，每次僅8到15秒即可快速簡單地完成測試。此經濟型設備無須電源，可任何地點檢查儀器和傳感器。每次成功的測試都自動記錄在數據存儲器中同時失敗的測試會提示儀器“出現故障”。還可選配便攜式打印機和打印文本結果。開機后可以簡單進行新鮮空氣標定。所有其它標定菜單選項均有密碼保護。

QUICK AND RELIABLE BUMP TESTING

Bump or function tests are necessary to check if the instruments are functioning correctly. Most national regulations require users to test equipment against a known gas concentration on a regular basis. Featuring adjustable bump test and calibration intervals, the Dräger Pac 3500 alerts the user when bump tests or calibration are required. If this warning is ignored or a test is unsuccessful, the instrument automatically displays an “out of order” error message. Performed together with the Dräger Bump Test Station, a typical bump test takes between 8 and 15 seconds and requires no additional power so that the test can be performed on site. Each test result is automatically stored in the event logger and, should hard copies be required, an optional printer can be used. If necessary, a fresh air calibration can be carried out during the start-up sequence. All other calibration options are only accessible via a password-protected menu.

升級款pac5500檢測氣體量程：

Pac 5500 CO （EU） 0 to 500 ppm

Pac 5500 H2S （EU） 0 to 100 ppm

Pac 5500 O2 （EU） 0 to 25 Vol.%

更多德爾格氣體檢測儀詳細資料介紹：www.king17。。ｃｎ